Clockwise Output set 1, CCW output set 2.4.5.3 Tick Use spindle motor Output and PWM Control, and.Please make sure that Output #1- Output #8 are ticked, other not.4.5 mach3 spindle start need to set 2 places.And VFD belong to analog voltage control.If the spindle is not started, please make sure that Make sure that the speed not 0 now, if it is 0, Please input 10000 of spindle speed, and Enter. Mach3 work, click spindle F5,move slider for speed adjustment. AVI, ACM are Analog voltage adjustment signal for spindle speed adjustment,10V is VFD output Voltage 4.1 Connect the spindle control line like the picture showed.Enter Mach3 configure, Open home/Limit, Tick the Home neg of the corresponding axis.If after back to origin point, direction and Switch is opposite, please.3.5 Executive command, start to back origin point.3.4 Mach3 main interface choose ref home.3.3 Connect the origin switch wire make sure switch signal is right.3.2 Open our driver: note mach3 /configure menu, open. 3.1nder Mach3 configure menu, open IO port/pin, then.Now please modify the output code of drawing little circle into I, J Code.2.1.3 It is not smooth when drawing little circle, you can see many line segments.With this number become bigger, it moving When drawing small circles, if the machine dithers, you can modify. 2.1.2 In general setting, choose “stop cv on angle>6 degree”.2.1.1 In general setting, please choose constant velocity mode. In Constant velocity mode, In a straight line corner, walked out of mach3 is rounded.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |